M25P80-VMN6TP Electronic IC Chips Flash memory with 75 MHz SPI bus interface

M25P80

8 Mbit, low voltage, serial Flash memory with 75 MHz SPI bus interface

Features

■ SPI bus compatible serial interface

■ 75 MHz Clock rate (maximum)

■ 2.7 V to 3.6 V single supply voltage

■ 8 Mbit of Flash memory

■ Page Program (up to 256 bytes) in 0.64 ms (typical)

■ Sector Erase (512 Kbit) in 0.6 s (typical)

■ Bulk Erase (8 Mbit) in 8 s (typical)

■ Hardware Write protection: protected area size defined by three non-volatile bits (BP0, BP1 and BP2)

■ Deep Power-down mode 1 µA (typical)

■ Electronic signatures

  – JEDEC Standard two-byte signature (2014h)

  – Unique ID code (UID) +16 bytes of CFI data

  – RES instruction one-byte signature (13h) for backward compatibility

■ More than 100 000 Program/Erase cycles per sector

■ More than 20 years’ data retention

■ Packages

  – ECOPACK® (RoHS compliant)

Description 

The M25P80 is an 8 Mbit (1 Mbit × 8) Serial Flash memory, with advanced write protection mechanisms, accessed by a high speed SPI-compatible bus.

The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction.

The memory is organized as 16 sectors, each containing 256 pages. Each page is 256 bytes wide. Thus, the whole memory can be viewed as consisting of 4096 pages, or 1,048,576 bytes.

The whole memory can be erased using the Bulk Erase instruction, or a sector at a time, using the Sector Erase instruction.

In order to meet environmental requirements, Numonyx offers the M25P80 in ECOPACK® packages. ECOPACK® packages are Lead-free and RoHS compliant.

Maximum rating

Stressing the device above the rating listed in the absolute maximum ratings table may cause permanent damage to the device. These are stress ratings only and operation of the device at these or any other conditions above those indicated in the operating sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Refer also to the Numonyx SURE Program and other relevant quality documents.

Note:

1. Compliant with JEDEC Std J-STD-020C (for small body, Sn-Pb or Pb assembly), the Numonyx ECOPACK® 7191395 specification, and the European directive on Restrictions on Hazardous Substances (RoHS) 2002/95/EU.

2. JEDEC Std JESD22-A114A (C1=100 pF, R1=1500 Ω, R2=500 Ω)

Stock Offer (Hot Sell)